Death Ray Designs Alien Technology Base Inserts (Beveled Skirmish Sizes) New

These Bases Inserts are precisely cut from a high-quality, paintable material. Choose from heavy card and 1.5mm acrylic. The inserts are packaged in a snap-close DVD case for easy, labeled storage between projects. With 45 inserts in a variety of sizes and designs you’ll have loads of great looking bases to make your whole army really pop!

Sizing: Not all bases are created equal. 25mm bases made by one company and 25mm bases made by another may have different diameters at the top. Please check the list of actual measurements next to each base size below and check your bases to see if they will fit.

Each set contains the following:

• 28x 25mm bevel base inserts (23.4mm)
  
• 11x 40mm bevel base inserts (38.3mm)
  
• 6x 55mm bevel base inserts (53.6mm)

Using Base Inserts

• Card

You can paint them already glued to the base or still in the sheet for easy bulk jobs. Paint them just like you paint your models with spray primer and normal acrylic paints. Caution against excessive use of washes is advised. When attaching inserts to bases and models to the assembled bases we recommend using superglue. For pewter models, it is best to pin them through the card insert to the plastic base underneath to ensure a strong permanent bond. If pinning, you may wish to remove a small circle of the insert with a hobby knife before drilling to avoid any possible frayed edges.

• Acrylic

Sanding lightly before painting is recommended to help with paint adhesion. Prime and paint like any model at this point. The bases shown are not included. Only the textured inserts are included in this package.