Lower Link Bushing Remover and Installer Tool Kit for Isuzu RT50 Trucks Suspension Arm Bushings OEM Alternative to 5-8840-0257-0 and 5-8840-2327-0

Removal 1. Raise the vehicle and support the frame with suitable safety stands. 2. Remove wheel and tire assembly. Refer to Wheel in this section. 3. Remove the tie-rod end from the knuckle. Refer to Power Steering Unit in Steering section. 4. Support lower control arm with a jack. 5. Remove the link nut. 6. Remove the nut and cotter pin. 7. Remove the shock absorber lower end from the lower control arm. 8. Remove the lower ball joint from the lower control arm. 9. Remove lower control arm nut and cam plate. 10. Remove cam bolt. 11. Remove lower control arm. 12. Remove bushing. Installation 1. Install rear bushing by using installer 5-8840-0257-0 and 5-8840-2327-0. 2. Install lower control arm. 3. Install cam bolt. 4. Install lower ball joint and tighten it to the specified in the shop manual. Install shock absorber and tighten it to the specified torque in the shop manual. NOTE: Apply oil to the thread. 6. Install stabilizer link and tighten it to the specified torque. Torque: 50 N⋅⋅⋅⋅m (5.1 kgf⋅⋅⋅⋅m/37 lb⋅⋅⋅⋅ft) 7. Install lower control arm nut and cam plate and tighten lower link nut finger-tight. NOTE: Apply oil to the thread. 8. Install nut and cotter pin then tighten the nut to the specified torque, with just enough additional torque to align cotter pin holes. Install new cotter pin. Torque to specifications.