The Simply Automated Anywhere 4-Rocker Wall Switch replaces a traditional wall switch for almost any lighting fixture to provide both local control over the connected light, as well as remote control over the other Simply Automated Anywhere devices (sold separately) in your home set to Channels 1, 2, 3, and 4 (see details below). The switch can also respond to remote Anywhere commands from other Anywhere transmitters, allowing you to add remote control to the connected light. Using the existing fixture wiring, the switch's main top-left rocker can control incandescent, fluorescent, halogen, LED, magnetic, and electronic low-voltage lighting transformers and ballasts up to 900 Watts (minimum 1W). The blue-green LEDs indicate the light's on/off status. The top-left rocker can also be used to control all Anywhere devices set to Channel 2. The top-right rocker controls all Anywhere devices set to Channel 3. The bottom-left rocker controls Channel 1, while the bottom-right rocker controls Channel 4. You could set only one device to Channel 1, for example, to control just that device, or you could set a group of devices to Channel 1 to control an entire scene with just one switch. It is important to note that the top-left rocker not only controls Channel 2, but is also set to respond as a Channel 2 device. Therefore, if more than one of these US2-V0 Series Switches is installed in a home, every Channel 2 rocker will control all of these switches' local loads simultaneously. NOTE: Requires hot and neutral connections. Wallplate not included. For indoor use only. Simply Automated's Anywhere Switches and Kits are incompatible with any of Simply Automated's PC-Configured, Pre-Configured, SimplySmart, or other UPB or UPStart products.
WARNING: 