eXtremeRate Hope Programable Remap Kit for Xbox Series X/S Controller, Upgrade Boards & Redesigned Back Shell & Side Rails & Back Buttons for Xbox Core Controller - Scarlet Red

NOTICE:
ONLY fits for Xbox Series X/S, for Xbox Core controller (Model 1914); Not compatible with xbox One other controllers.
The controller is NOT included.
You need to take apart your controller for installation, high hands-on skills required.
Installation Tips:
Installation difficulty: high
Patience needed: high
Please view the installation video carefully before installation.
Get the installation video guide on YouTube by searching “eXtremeRate Hope Remap Kit for Xbox Series X/S Controller".
If you have any problems during the installation process, please feel free to send us a message.
The FPC board needs to be soldered and the FPC board should be fixed with double-sided tape before soldering.
When soldering, please be careful not to pull the Hope-FPC cable, the soldering time of each TP point is less than 1 second.
After soldering, it can be tested with the test board.
If all the LEDs on the tester board are not lit, please check P2 and TP35 solder points whether soldering correctly.
If only some of the LEDs are not lit, please check the corresponding solder points whether soldering correctly.
Turn the toggle switch to right, the blue light will be on and then enter buttons programming mode.
You can activate the remap program during the game and assign maximum of 14 buttons (A, B, X, Y, L3, R3, LT, RT, LB, RB, Up, Down, Left and Right ) to the back buttons.
Package Included:
1* Hope remap board
1* Hope tester board
1* Hope cable FPC1 & FPC2 & FPC3
1* Redesigned back shell with battery cover
1* Left right side rails
4* Back buttons
1* Prying tool
1* Cross screwdriver
1* T8h screwdriver
1* T6 screwdriver
29* Screws
Note: The controller and other parts are not included.