Cressi Gara Turbo Impulse HP Compact Fins

Following the Impulse project, Cressi has successfully transferred the same design parameters for S-shaped undulating deformation to this innovative fin. This particular movement permits a notable accumulation of elastic potential energy in the blade, which is released in the return kick, transforming into thrust. The fins blade is available in two different materials, the thermoplastic or carbon fiber. The thermoplastic rubber used for the water channeling rails is extremely flexible and soft so as not to undermine the intrinsic characteristics of the blade. The Cressi Gara Turbo Impulse High Performance Compact Fin Rails, has an extremely thin and light blade in compound made of elastomer techno polymers developed by Cressi. Stringer consisting of techno polymers with elastomeric loads with high flexural modulus.In the Carbon Fiber version the effect has been achieved using a finite element programmed that enables the performance offered by carbon fiber to be exploited to the fullest. The blade is all-carbon fiber. The fiber is imported from Japan. The shaped and processed sheet is then produced in a specialist plant in Turkey. The blade is subsequently finished with an industrial co-molding process at Cressi's Genoa plant. The elevated chemical bonding achieved between blade and rail, effectively creating a single piece, has permitted the elimination of the rigid glue that prevented the carbon fiber blade from flexing naturally. The thermoplastic rubber used for the water channeling rails is extremely flexible and soft so as not to undermine the intrinsic characteristics of the carbon fiber. The blade is therefore, less fragile and more protected by the rubber. The end result is a very light fin, with every square millimeter exploiting the flexibility of the carbon fiber to the fullest.Both versions foot pocket/blade angle is 29-degrees on this modular detachable fin.The Cressi Gara Turbo Impulse and Carbon Fins provide superior performance and comfort while finning. Self-adjusting foot pocket. With the included new insole for Gara Modular fins is recommended for use with thin boots in temperate waters, because it improves the kick performance. The semi-rigid material of the insole is completely recycled. The insoles are supplied as a pair (right and left foot) and can be cut into their shape in three different sizes, according to pre-printed guidelines. Down-size Gara Fins foot pocket preformed sole. Easily adjust size with non-corrosive plastic construction. Fins are available in multiple sizes and are made or assembled-in Italy.