Stops the competition dead in their tracks. Results in torque and power gains across the full operating rpm range, starting right off idle and marching to the shift point in each gear.
Derringer is dyno calibrated to use multiple data inputs such as throttle position, rpm, vehicle speed, AFR, Knock and coolant temperature, just like your engine's ECU. Its microprocessor based electronics are able to actively and safely optimize calibrations in real time. No competitive product does that.
The electronics are molded into a waterproof connector, which is easily concealed and communicates using B-Bus (Banks Bus) with other devices such as our iDash 1.8 SuperGauge/Control Center. The Derringer connects in line with the Throttle Inlet Pressure (TIP) and Manifold Absolute Pressure (MAP) sensors. But, unlike others it also connects to the vehicle's OBDII diagnostic bus connector. A CAN (controller area network) transceiver chip communicates with OBD or B-Bus allowing our microprocessors to talk with the vehicle. And, Derringer's special coolant temp watchdog prevents power addition when the engine is too cold or overheated. The Derringer also auto-adjusts power if knock occurs due to bad fuel. Maximum safe power is all automatic with a Derringer, you just choose your setting.
Features - Derringer System Gen 2 Use with Idash for 2020 6.6L Gm 2500 L5P
- Easy Install
- Loaded with Features
- Destroys the competition, not your vehicle!
- ActiveSafety protects engine/powertrain
- Adds up to 79 hp and 138 lb-ft
- 0-60 mph 9% faster than stock
- Kicks you back in your seat
- 6 power levels
- Interfaces with OBDII Port (On-Board Diagnostics/Information) to communicate directly with the vehicle ECU
- Best results with 91 octane
- Airflow improvements recommended
Compatibility: Specifications - SKU: ZX9MYRD585052
WARNING: 