Mini Electric Water Heater 10L Tank Under Sink Hot Compact 110 Volt 1500W Warmer White

Specifications

Color: White

Style: Modern

Anti-freezing: Yes

Shape: Rectangle

Installation Required: Yes

Control Mode: Mechanical

Material: 316 Stainless Steel, 304 Stainless Steel, Plastic

Number of 316 Stainless Steel Heating Tubes:1

Mounting Type: Wall-mounted, Vertical

Water Inlet Mode: Lower Water Inlet

Water Outlet: Top outlet, Lower Outlet

Power Source: Corded Electric

Plug: US Standard

Efficiency: Ⅱ

Wire Section: 2.5mm²

Heating Capacity: 75%

Model: DSZF-A18-10

Capacity: 10L/2.64gal

Voltage: 110V, 50Hz

Rated Power: 1500W

Rated Pressure: 0.7MPa

Waterproof Level: IPX4

Temperature Regulation Range: 30-65°C/86-149°F

Power Cord Length: About 1m/3.28ft

Pipe Length: About 60cm/23.62in

Reserved Installation Height(Upper Outlet): 50cm/19.69in

Product Size: 35.5*30*35.5cm/13.98*11.81*13.98in

Package Size: 40*35.2*41cm/15.75*13.86*16.14in

Gross Weight: 5.5kg/12.13lbs

Package Included

1*Safety Relief Valve

1*Hose

1*English Manual

All Accessories for Assembly

Notes

A 19.69-inch space needs to be reserved for the installation of an upper water outlet.

Please beware of potential safety hazards when using electricity. Improper installation may lead to significant safety hazards. It is important to ensure that it is installed by professionals and not install it on your own.

The installation of this product requires the following conditions: 0.1MPA water pressure tap, dual-use cold and hot water faucet, and three plug power sockets (the installation position should have a drop of more than 16.4 ft from the water tower). Please make sure that the grounding wire is properly connected during installation and do not use a mobile outlet.

Please do not install the machine upside down, sideways, or upside down. The top water outlet is recommended to be installed under the water basin. Please install an electrical barrier(not included) at the red hot water outlet and a pressure relief valve at the blue cold water inlet. Please make sure the water heater is mounted firmly to bear the weight of the water heater after it is filled with sufficient water. It should be connected to water first and then to electricity.

When using this product for the first time, please rinse the water thoroughly before turning on the power (do not use it when the water is off). Please note that the connecting pipe between the inlet pipe and the water heater must be an all-metal pipe. When not in use for a long time (more than 24 hours), please turn off the water source and cut off the power supply.

After long-term use, the scale will gradually accumulate inside the water tank. It is recommended to clean every 12 to 18 months to extend the service life of the inner tank and heating tube and ensure clean water quality. The water passing through it cannot be directly consumed.

Please note that it is strictly prohibited to block the outlet of the one-way safety valve. When the inner liner is heated by thermal expansion, the additional pressure will be greater. When the pressure reaches 0.7MPa, the one-way safety valve will automatically drip water to relieve pressure, ensuring safety.

Please allow the slight color difference caused by the shooting light and 1-3cm error due to manual measurement, and make sure you do not mind before you order.