Sipeed Tang Nano 20K Development Board SPI Open Source FPGA Retro Game w Speaker Without horn and welding pins

Sipeed Tang Nano 20K development board SPI serial communication NES simulator open source FPGA game with Speaker

Description:
Tang Nano 20K is a new development board in the SIPEED Tang Nano series. It has the same number of logic units as Tang Primer 20K, but the volume is compressed to the ultimate 5.5x2.3 cm!
Its built-in low-latency 64Mbits SDRAM makes it easier to run NES emulators and run soft-core linux systems better.
The onboard download chip is upgraded to a USB2.0 HS interface, which has the functions of high-speed JTAG download, serial communication, high-speed SPI reception, and precise clock configuration~
Compared with the previous Nano series of FPGA chips, it is a huge upgrade. Maker design? Retro game console? DIY development? Learning Verilog? RISC-V soft core? All can satisfy you.

Programming experience:
Compared with common FPGA development environments on the market, the size of the IDE installation package required by Tang Nano 20K is less than 200MB; the space occupied after installation is close to 500MB, which greatly saves hard disk space. The flow of using the IDE is extremely streamlined so that beginners will not be overwhelmed by too many options. Compared with other IDEs on the market, which can take five minutes to program and ten minutes to synthesize, the IDE used by Tang Nano 20K can bring a pleasant experience of five minutes to program and ten seconds to synthesize.

Download method:
Tang Nano 20K has an onboard downloader, no other downloader is needed for programming.

Specifications:
Kit Model: Tang Nano 20K
Main Chip: GW2AR-LV18
LUT: 20736
Block RAM: 828Kbit+41Kbit
18 x 18 Multiplier: 48
PLLs: 2
SDRAM: 64Mbit with 32bit width
External Flash: 64Mbit QSPI NOR
Audio DAC: Support
SD Card: microSD
LCD: Support RGB LCD
WS2812: Support
HDMI: Support
Accurate Clock: Support
Onboard Debugger: USB to JTAG & UART, USB to SPI

Package Included:
Option1:
1x Tang Nano 20K (no soldering pin header)
1x USB TYPE-C data cable
2x PIN Header
1x Fan
Option2:
1x Tang Nano 20K (soldering pin header)
1x USB TYPE-C data cable
Option3:
1x Tang Nano 20K (no soldering pin header)
1x USB TYPE-C data cable
2x PIN Header
1x Speaker
Option4:
1x Tang Nano 20K (soldering pin header)
1x USB TYPE-C data cable
1x Speaker