Replacement for:

2003-2008 Toyota Corolla

Part Number: 6221-0120L,6221-0120R

HOLLANDER:114-58983DL,114-58982DR

OEM: 81150-02360, 81110-02370, 8115002200, 8115002210

Partslink number: TO2502154, TO2503154, TO2503160, TO2502160

Specifications

Housing Color: Black / Chrome

Lens Color: Clear

Headlight Style: Factory

Assembly Type: Composite

High Beam Headlight Bulb:9005 (Not Included)

Low Beam Headlight Bulb: 9006 (Not Included)

Fitment Type: Direct Replacement

Material: ABS Plastic Housing / Polycarbonate Lens

Placement on Vehicle: Front, Left, Right

Package Includes: 1 Pair of Driver & Passenger Side Headlight Assembly

Safety & Fashion

Highly reflective amber reflectors offer OEM compliances with DOT and SAE standards.

This headlights upgrade the face of your vehicle with clear style and extreme range.

Easy Installation

Plug-n-Play Operation, Direct Bolt-On OE Fitment or Replacement for the Stock Unit.

Requires no Modification or Drilling.

Note: Installation instruction is not included. Professional installer is highly recommended.

Clear Lens

More safety and brighter. Lens offer a high impact resistance.

This headlights allow you to see the road in front of you clearly during the night and in any bad weather that may arise.

High grade ABS plastic

Special housing is resistant to water, impact, and corrosion, long lasting and durable.

Please Note:

Before you begin to adjust the light, make sure check the alignment of your lights first. Park the vehicle about 10 to 25 feet from the wall with the lights aimed at the wall. The centerlines of the headlights should not be any higher than 3.5 feet above the ground.

1. Find the adjustment screws.

Firstly, locate the adjustment screws on your vehicle.

2. Adjust the headlights individually.

The headlights should be adjusted one at a time. Put a rag or towel over a chair in front of the light you want to block. Covering the light assembly directly can damage the plastic lens.

3. Adjust the vertical field.

The screw on the top of the light housing should be turned clockwise to raise the lights and counterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the light beam shines directly on or just below the center of the tape line on the wall.

4. Adjust the horizontal field.

The screw on the side of the light housing should be turned to get the right/left adjustment correct. Adjust the lens so that the most intense part of the beam is to the right of the vertical line.

5. Test your result.