Innovis Better-Bench InvisaBolt Support System - 2 Bolts - for Benches BB-R26 and BBADJR

BETTER-BENCH INVISABOLT SUPPORT SYSTEM

**** THIS LISTING IS FOR 2 BOLTS ****

INVISABOLT™ The floating bench mounting system

Size 3/4" x 17.5"

Mid point corbel support, For use with BB-ADJR and BB-BR26 when necessary

Better-Bench is an easy to install bench-forming system that replaces the complex methods currently in use.

TO DETERMINE SUPPORT REQUIREMENT FOR BB-R26:

This unit may be mounted on THREE (3) support walls WITHOUT any additional support or blocking being necessary*.
TWO (2) wall installation with one end of the bench “open” requires the use of either a BT-17S (SOLD SEPARATELY) OR (1) Invisabolt (SOLD SEPARATELY) with 4×6 minimum wood blocking.
A “FREE FLOATING” Installation (without any side wall connection) will REQUIRE (2) Invisabolts with 4×6 minimum wood blocking for the full length of the bench.

TO DETERMINE SUPPORT REQUIREMENT FOR ADJR:

Mounting wall to wall up to 36"- No additional support required
Mounting wall to wall up to 63" - One(1) BT-17S centered in span OR Two(2) Invisabolt supports
Mounting on a back wall and one side wall up to 36"- One(1) BT-17S within 6″ of open-end OR 2 Invisabolt supports
Mounting on a back wall and one side wall up to 63" - Three(3) Invisabolt supports required
Mounting with no side support up to 36" - Two(2) Invisabolt supports required
Mounting with no side support up to 48" - Three(3) Invisabolt supports required
Mounting with no side support up to 63" max span - Four(4) Invisabolt supports required

Futures:

Engineered 400 lb load capacity on all Better-Bench products, 100 lb load capacity on the Better Tray (BT-17)
Install before or after finish tile is applied to vertical surfaces.
This fully independent supporting unit, can be mounted to most vertical surfaces quickly and efficiently, saving the installer valuable time.
Self-supporting, one-piece frame is easy to install with supplied fasteners, requiring no additional waterproofing or structural reinforcement.
Use in wet or dry locations; mount over any U.B.C. approved substrate material.
Takes only minutes to mount, place mortar mix (sand & cement), and tile as desired.
Long lasting and corrosion resistant materials throughout.