EAGLE 1 EPDM Flexible Roofing Pipe Flashing Retrofit Split Zipper Boots - On Site Adjustable Roof Pipe Jack Boot with Round Base (Multiple Sizes) (No. 1)

Product Description

EAGLE 1 Flexible Roofing Pipe Flashing Zipper Boots are high quality and come in multiple sizes.

Features:
- High quality
- Comes with stainless steel clips to close the seam of the boot
- Easy to install around a pipe or electrical service pole or conduit
- Easy to read dimensions
- 3 sizes to choose from
- Flexible aluminum collar can be formed to fit any metal roof panel
- High quality EPDM rubber material
- Withstands temperatures to 239 F
- Eagle 1 Zipper boots are perfect to use when the pipe boot can not be installed from the top of a pipe. If you have questions send us a message and we will be glad to help any way we can.

Suggested installation steps.
1. Cut the top of the boot to fit the diameter of the pipe. Start out a little smaller and trim to a tight fit.
2. Form the flexible aluminum collar to fit the metal roofing panel profile around the pipe.
3. Trace the outside edge of the collar with a pencil to show where to apply the sealant.
4. Apply sealant to the inside of the circle.
5. Set the collar into the sealant and install fasteners into the collar 1 inch apart. This ensures the sealant will make a water tight bond between the bottom side of the collar and the to of the roof panel.
6. Install the stainless steel clips onto the seam of the boot by squeezing the clip with your fingers or a pair of pliers. Clips should be about 1/2 inch apart.
7. Apply a bead of sealant at the top cut edge around the pipe.

At Eagle 1 we stand behind all of our products! Thank you for shopping. We know you will like our Flexible Roofing Pipe Flashing Zipper Boots! Buy with confidence!