SpecificationsSpecification of light bar: 30CM 12 Light Beads
Use: Automobile and motorcycle decorative lights
Material: 5050 Tri-chip luminescence Over 1000MCD per lamp
Size:Length: 30CM Width: 1.0CM Height: 0.3CM
Base color: black
Lifetime: 10,0000 hours
Withstand temperature: -20℃ to 50℃,
Operating temperature: 5℃ to 50℃.
Package List6*LED light strips
★ Main advantages1. power saving, very low heat generation, low power consumption only, suitable for any 9-14V car power supply.
2. Long service life, this product uses imported led wick.
3. Fully sealed waterproof design (all PVC solid seal), 100% waterproof.
4. Pressure-resistant, shockproof, impact-resistant, soft material, durable.
5. High luminance, long life, uniform brightness, no chromatic aberration, wide coverage.
Easy to install, can be installed in the car or outside the car, clean the car table paste place, air dry and use glass glue to paste the light bar, and then tie with a tie on also can.
1) Surface sealant
2) Waterproof class is IP68, suitable for indoor and outdoor use.
3) DC12V voltage
4) Sturdy, high shock resistance
5) Low energy consumption, high brightness
6) No radiation
7) Flexible, compact size, easy to install
★Main useNew LED soft strip lights in various colors with DIY, highlight personalized lights. Customers can also choose different lengths according to their car models. It can be used as chassis lights, mesh lights, wheel hub lights, brake lights, interior footlights, roof reading lights, trunk lights, back up lights, etc.
Buyers can also choose different lengths and colors according to their own needs. Suitable for all models.
Installation: The LED ambient light is a new 30cm flexible strip of LED lights on the left and right of the driver's console, directly fixed on the left and right of the driver's console, and then connected to the door lights or reading lights, suitable for all models.
Special Warning!Before installation, use the 12V battery power supply of the car to test the light without any problems before starting installation, the correct way is to take out the light strip from inside the package and carefully paste it on the location to be installed, and fix it directly! The power supply can be directly connected in parallel to the wide-lamp (small light power cord), it is forbidden to connect directly (not through the fuse) to the battery power!
