DIGITEN WTC200 Wireless Temperature Controller Thermostat Outlet Remote Control Thermometer with 2m/6ft NTC Temp Sensor Probe Heating Cooling Mode for Fan Heater Greenhouse Homebrewing Repti

• 📡【Wireless Remotely Control】: Remotely set and control, portable design, which is more convenient and handy. Communication range is 50-100m in open area. It can save all settings even if the power failure.
• 🕹️【Easy to Use And Program】: Accurate reading temperature for LCD display with back light. Freely switch between ℃ and ℉.
• 💰【Save Money】: The thermostat will make your life not only comfortable but energy efficient. The thermostat turns on and off appliances connected to outlet based on the target temperature, thus saving money on your electric bill while maintaining comfort.
• 💯【High Accuracy And Safe】: Come with a highly accurate temperature sensor, ambient temperature is detected automatically by the sensor on the receiver socket. High and low temperature alarms are available, the maximum load can reach 12A, 1300W.
• 🎈【Widely Used】: Widely used for greenhouse,mushroom house, reptiles breeding, pet feeding, wine cellar, cigar storage, home brewing, seed germination, fermentation, baby room, attic fan, swamp cooler, evaporative cooler, space heater, wall panel heater, electric fireplace heater, garage, etc.

Specifications

• Load Capacity: 100-240VAC 12A, 1300W@110VAC, 2640W@220VAC
• Remote Batteries Required: 2×1.5V AAA (Not Included)
• Transmission Distance: 50-100m
• Measuring Temperature Range: -10℃~80℃, 14℉~176℉
• Temperature Accuracy: ±0.1℃/℉
• High/Low Temperature Alarm: 0℃~80℃/32℉~176℉
• Remote Refresh Frequency: 20 Seconds
• Temperature Probe: Plug In The Receiver

Note, Multiple sets of equipment will not interfere with each other. if you want one remote to work only one outlet, when pairing, please remove the batteries of other remotes and keep only one remote control is in active (power on) state.

• Directly connect to cooling or heating device after setting.
• Set Run＞Stop, it will be in cooling mode.
• Set Run＜Stop, it will be in heating mode.

• Temperature is detected by the receiver.
• Can be monitored and contorlled in different rooms with 50-100m.

• The Low alarm and High alarm are not equal to the Run temperature and Stop temperature.
• The High alarm and Low alarm are turned off by default.
• To turn on the alarms, long press and hold the SET button, then press the DOWN/UP button to set the High/Low alarm velue you desire on the High/Low page.

• 2m/6ft probe cable.
• The NTC probe is waterproof.
• Place the probe where the temperature needs to be detected.