BRIGHTLINES Black Aluminum Roof Rack Crossbars Replacement for 2013-2018 Hyundai Santa Fe, Set of 2

Fit was perfect, allows enough clearance for my panoramic roof. Old generic steel roof rack never fit as well and would rust if left on all year. This one is all aluminum except for the galvanized bolts on under side that connect the crossbar to the clamping part (preadjusted specifically for this car -don't tinker with the size, the rear and front bars are not the same length to match the non-parallel roof rails of the car -rear is narrower), and the stainless steel bolt on the clamping part (too bad all the bolts aren't stainless steel). Bars are very aerodynamic with slight upward lift on rear edge, so pay attention on install on which edge is forward- underside has mark (raised bar is forward edge). Slim clamping part is a plus in looks and adds to the aero benefit as well. Very quiet at high speed, even with my Thule ski rack attached. Looks like the factory issued style, but height is between the panoramic and bare roof product. Comparing to the panoramic roof product offered by Hyundai, it's probably more aero than the factory one, since it is lower. And costs less than a third the price. Caps cover the attaching bolts, use care when capping. I used an ice pick to help guide the plastic stems in position to provide a flush finish. Pay attention to this detail, since there is no lock, just like the factory one. Hiding the bolts will deter theft. Same risk as the factory issue. If you want more protection, swap out the stainless steel clamping bolt with a stainless steel tamper proof torx bolt. Too bad the manufacturer didn't think about that one. Happy Skiing!