CONFAST 1/2" (Inside/Screw 1/2"-13 Diameter) Drop-in Anchor Zinc Plated with 1 Setting Tool (50 per Box)

Applications

The anchor is made from Carbon Steel, and is Zinc Plated. This anchor is designed for use in Concrete only, and should never be used in block or brick base material.

Environment

The anchor is designed for use in a Dry environment.

Hole Diameter/Bit Diameter

The anchor requires a 5/8" hole to be drilled in the base material (Concrete only). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.

Minimum Embedment

The minimum anchor embedment into the concrete is 2". Therefore, the anchor must be installed so that a minimum of 2" of the anchor is embedded into the concrete.

Spacing between Anchors

Each anchor must be spaced a minimum distance of 6-1/4" from each other when measured center to center.

Edge Distance

It is very important not to install the anchor any closer than 3-1/8" from an unsupported edge of the concrete.