G2 is pleased to introduce the new hammer differential covers for the front dana 30, dana 35 and dana 44 axles for the jeep jl wrangler and jt gladiator. Oem differential covers are often made of thin stamped metal that is vulnerable on the trail. Hit a rock or other obstacle and they can bend or puncture. Once that happens, differential fluid can easily leak out leaving you stranded on the trail. The new g2 hammer is a tough and durable differential cover for the jeep jl wrangler and jt gladiator that prevents this from happening. Hammer m186 iron differential covers are designed to protect from potential damage to the gears, locker and carrier bearings, not to mention a difficult, messy trail fix. even more common, though less catastrophic, is peel back" that can occur when sliding over a rock causes the lip of the cover to peel up, allowing your gear oil to drain causing a hazard for both your jeep and the environment.Manufactured from highly ductile nodular iron the same material drag racing differential housings are cast from to handle thousands of horsepower. The design of the hammer m186 iron differential cover incorporates pockets to protect the diff cover bolt heads from trail damage, while the profile of the diff cover acts as a ramp to help slide your jeep up and over the most troublesome obstacles. The ramp profile also results in an extremely thick & up to 1" thick cross-section around the bolt ring, where contact with the rocks is most likely. Throughout the rest of its cross-section the hammer m186 iron differential cover is the thickest cast differential cover on the market, from 7/16" to a brutal 1/2" thick at the outermost surface.
WARNING: 