JVCC HZ-DT1 Hazard Duct Tape: 2 in. x 60 yds. (Black with Yellow stripes)

JVCC HZ-DT1 Hazard Duct Tape is a high-quality polyethylene-coated cloth duct tape, featuring a residue-free natural rubber adhesive from most surfaces. Striped safety warning duct tape is used for permanent and temporary marking of hazardous areas, floors, aisles, stairs, wires, and cords. HZ-DT1 Hazard Duct Tape is ideal for use in manufacturing, as well as in convention & exhibition halls and residential & commercial sites.

JVCC HZ-DT1 Hazard Duct Tape is available in widths from 1-inch to 8-inch for jobs big and small. Clearly mark floors, surfaces, and anywhere you need a brightly colored and clearly defined multi-use tape. Hand-tearable and easy to use and unwind so wide widths can be used. Peels off easily upon removal and leaves no residue on most surfaces. The diagonal stripes on the tape are approximately 2-7/8 inches long (measured at the edge of the roll).

NOTES: Sizes shipped will typically be the tape industry standard metric-cut sizes, i.e. 24mm for each 1 inch of nominal tape width ordered (rolls are approximately 5% narrower than the nominal size). This product's actual size is 48mm x 55m. This tape is typically cut to width from log rolls so most sizes ship on non-branded plain white cores. As with any adhesive tape product it is always the user's responsibility to determine that the product is suitable for their intended use; e.g. if you want to remove a product cleanly from a specific type of substrate please test on an inconspicuous area first. Warning: This product can expose you to chemicals including Carbon black (airborne, unbound particles of respirable size), which is [are] known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov/.

Technical Information
- Core: 3 inch diameter
- Backing/Carrier: 70 mesh polyethylene coated cloth
- Adhesive: natural rubber
- Thickness: 11.8 mils (carrier, adhesive)
- Adhesion: 29 ounces per inch (to stainless steel test panel)
- Tensile Strength: 35 pounds per inch (longitudinal)
- Service/Operating Temperature: -31F to 176F