JVCC NS-2A Premium Non-Skid Tape is a premium 32 mil 60 grit silicone carbide high traction, anti-slip tape. This non-skid tape has a waterproof backing and is coated with an aggressive acrylic adhesive (more permanent than a synthetic rubber adhesive). JVCC Non-Skid Tape is used indoors or out on stairs, pool areas, ramps, work areas, skateboards, and garage steps. The 60 grit silicone carbide surface is similar in feel to 60 grit sandpaper, therefore, it is not appropriate for bare feet. NS-2A complies with OSHA 1910.263(3). Also please note the semi-transparent/translucent color is only partially transparent while the white color is completely opaque. For bare feet please see a rubberized non-skid tape like the ISC 3500 Jessup Safety Track. JVCC NS-2A is not coated with an adhesive that can be submerged or put underwater. So if when applied there is any gaping which would allow water to seep underneath to the underside of the tape water would degrade the adhesive pretty quickly. Also the substrate it is applied to must be dry, in good condition, and free of any debris when the tape is applied so the adhesive bond can form correctly.
NOTES: Sizes shipped will typically be the tape industry standard metric-cut sizes, i.e. 24mm for each 1 inch of nominal tape width ordered (rolls are approximately 5% narrower than the nominal size). This product's actual size is 150mm wide. As with any adhesive tape product it is always the user's responsibility to determine that the product is suitable for their intended use; e.g. if you want to remove a product cleanly from a specific type of substrate please test on an inconspicuous area first. In the photo the colors are the following (starting from the leftmost column and working down): Fluorescent Orange, Fluorescent Yellow, Yellow with Black stripes, Orange, Yellow, Black, Red, Grey, White, Blue, Green, Clear/Translucent. Warning: This product can expose you to chemicals including Toluene, which is [are] known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov/.
Technical Information - Core: 3 inch diameter
- Backing/Carrier: 60 grit silicone carbide
- Adhesive: acrylic
- Release Liner: paper
- Standards Met: OSHA 1910.263(3)
- Thickness: 32 mils (carrier, adhesive)
- Adhesion: 60 ounces per inch (to stainless steel test panel)
- Tensile Strength: 36 pounds per inch (longitudinal)
WARNING: 