Scapa S301 Double-Sided Clear UPVC Tape: 6 in x 60 yds. (Clear)

Scapa S301 Double-Sided UPVC Tape is a clear UPVC film coated on both sides (AKA double-coated) with an exceptionally high tack, high peel, acrylic adhesive system. Scapa S301, also known as Dublfilm S301, performs well in many difficult bonding and splicing applications. Typical uses for the tape include product assembly, difficult splicing applications, lamination to EPDM rubber and demanding bonding applications like to sports jerseys. Please note S301 is coated with 3.5 mils of acrylic adhesive on both sides and therefore does have a strong adhesive scent. Ships on an unbranded neutral core since it is cut from log rolls.

Features and Benefits

• Exceptionally high tack and peel.
• UPVC film allows conformability.
• Meets the compositional requirements of FDA regulation 21 CFR 175.105 (adhesives) for indirect food contact.
• High adhesive mass provides excellent gap filling properties.
• Excellent resistance to environmental extremes.
• Exhibits excellent adhesion to ether and ester foams.

Made in Canada. NOTES: Sizes shipped will typically be the tape industry standard metric-cut sizes, i.e. 24mm for each 1 inch of nominal tape width ordered (rolls are approximately 5% narrower than the nominal size). This product's actual size is 144mm x 55m. This tape is typically cut to width from log rolls so most sizes ship on non-branded plain white cores. As with any adhesive tape product it is always the user's responsibility to determine that the product is suitable for their intended use; e.g. if you want to remove a product cleanly from a specific type of substrate please test on an inconspicuous area first.

Technical Information
- Core: 3 inch diameter neutral
- Backing/Carrier: unplasticized polyvinyl chloride (UPVC) film
- Adhesive: acrylic
- Release Liner: paper
- Standards Met: FDA Title 21 Part 175 Subpart B Section 175.105
- Thickness: 12 mils (carrier, adhesive, liner) 8.5 mils (carrier, adhesive) 3.5 mils (adhesive)
- Adhesion: 167 ounces per inch (to stainless steel test panel)
- Service/Operating Temperature: -40F to 200F