Instructions
It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Remove pets and birds and cover fish aquaria before space spraying or surface applications. This product is NOT FOR USE ON HUMANS. If lice infestation should occur on humans, use a product labeled for use on humans. For space and broadcast treatments vacate room after treatment and ventilate before reoccupying. Do not allow children or pets to contact treated areas until surface is dry. SHAKE WELL BEFORE USING. To kill Lice and Louse Eggs: Spray in an inconspicuous area to test for possible staining or discoloration. Inspect again after drying, then proceed to spray entire area to be treated. Hold container upright with nozzle away from you. Depress valve and spray from a distance of 8 to 10 inches. Spray each square foot for three seconds. Spray only those articles that cannot be either laundered or dry cleaned such as mattresses and furniture. Allow all sprayed articles to dry thoroughly before each use. Do not use on pillowcases, sheets or clothing. Bedbugs: Spray mattresses, particularly around tufts and seams. Allow mattress to dry thoroughly before use. After mattress is dry, cover with mattress cover and sheet. Do not use mattress without cover. Take beds apart and spray into all joints. Treat baseboards, moldings and floors. To kill house dust mites: (Dermatophagoides Spp.) This Lice Control Spray is a multi use insecticide spray that controls house dust mites that may cause asthma, hay fever, rhinitis, watery eyes and sneezing. One treatment lasts for up to 8 weeks. On upholstered furniture: Test fabric in an inconspicuous area to insure dyes will not bleed. Hold container upright with nozzle away from you. Depress valve and spray from a distance of 8 to 10 inches. Spray all fabric surfaces until damp. Spray to the point of dampness but not run-off. Do not use on delicate fabrics. Furniture to dry thoroughly before use. On carpets: Spray over entire carpet until damp. Spray to the point of dampness but not run-off. Hold the nozzle approximately 12 to 18 inches from the carpet surface and spray in a sweeping motion. Use an overlapping pattern to insure total coverage. After application, brush the surface of the carpet with a broom or brush to insure deep penetration. Allow the carpet to dry thoroughly before reentering the treated area. Drying time can be accelerated by using a fan. On mattresses: Spray to the top, bottom and sides of mattress until damp, paying particular attention to tufts and seams. Allow to dry thoroughly before using. After mattress is dry, cover with sheet. Do not use without a mattress cover. Since vacuuming stirs up dust in the air, those with allergies should have another person vacuum or should wear a dust mask and use a vacuum with a high efficiency particulate (HEPA) filter.
