H/R Springs 1055665

H&R wheel spacers compatible with CHRYSLER Crossfire

Width: 2x5mm
PCD: 5x112
Centerbore: 66,5
System: DR
Offset:
Screw diameter: M12x1,5
H&R Spacers DR 2x5mm 1055665 for CHRYSLER Crossfire H&R TRAK+ Wheel spacers System DR improve the look as well as the handling of your car and are compatible with both stock and aftermarket wheels. Wheel spacers are an ideal complement to lowering springs or coilovers. By installing H&R spacers, the wheels fill the wheel arches properly, which significantly improves the look and the driving behavior.

Product benefits:

High strength, light weight aluminium/magnesium alloy

Precision CNC machined

Hard anodized for greater surface hardness and corrosion resistance

Fit either stock or aftermarket wheels

Compatible with OEM and aftermarket suspension systems

Engineered and manufactured in Germany

The H&R Spacers 2x5mm 1055665 should be fitted between the wheel and the axial hub using longer bolts.

Please note additional information and vehicle-specific technical notes!

DR = The wheel spacer should be fitted between the wheel and the axial hub using longer bolts not supplied - please order separately. When ordering the longer bolts please state which cone type you require (i.e. taper round loose round or flat) and the required extra length. All screws for the DR systems have to be orderded separately.

18.) These spacers without a double-sided centering are only useable for cars with a sufficient length of the centering to be able to center the wheels enough despite the spacer.

2.) Only valid in Germany

25.) Not usable with steel-rims!

27.) Only for the front axle.

28.) Only for the rear axle.

3.) All DR-Systems require longer wheel-bolts. These have to be ordered separately. When ordering wheel-bolts please follow these guidelines: If possible name the type of the wheel when ordering. New bolts must be longer than the original ones by half of the total Track-widening. For example: With a 30 mm DR-kit you will require bolts that are 15 mm longer than the original bolts. The bold-head must be identical to the existing bolt: Taper 60° Round-head for M12/d24 mm for M14/d28 mm Round-head for M12/d26 mm (e.g. OE VAG-wheels) Flat-head with disc for CITROEN/PEUGEOT-vehicles M12x1 25 Flat-head for PORSCHE-original-wheels M14x1 5 Safety Guidelines (No. of turns for wheel screws) M12x1 5 = 6 5 turns = approx. 10 mm of load bearing shaft length M12x1 25 = 8 0 turns = approx. 10 mm of load bearing shaft length M12x1 75 = 6 5 turns = approx. 12 mm of load bearing shaft length M14x1 5 = 7 5 turns = approx. 12 mm of load bearing shaft length 1/2"UNF = 8 0 turns = approx. 11 mm of load bearing shaft length Please ensure that the wheel screws do not damage any part of the brake system (ABS sensors etc.) Turn the wheel first by hand and check clearance on the inside (max. tolerance for some vehicles is only 2 mm (RA Mercedes).