Aquapac Waterproof Radio Microphone Case, Small

Inner Case Quantity: 1
Master Case Quantity: 1

What’s so special about this case?

• This case is designed for electronics which require a thin wire to be connected to them at all times.
• The special wire-thru clamp at one end allows that wire to stay connected, and be waterproof.
• The case is usually used by professionals with specialist electronic devices.
• Suits mini radio mics from brands such as Audio Ltd and Audio Engineering Micron.

Key Features

• Use all buttons and switches through the case
• Also protects from dust, dirt and sand
• Supplied with a belt, or you can use your own belt
• Like most Aquapac cases, it’ll float if you drop it in the drink
• Seals around a wire of up to 1/10th in / 3.5mm diameter
• The seams are high-frequency welded to form a super-strong bond.
• This case features our ‘TC’ Aquaclip which makes the case waterproof to IPX6. Temporary immersion is fine, but not continuous immersion.

Important Notes

• Cases with this clamp are for surface use only, but will offer protection from temporary submersion. They are not recommended for prolonged immersion.
• When not using the case leave the TC clamp open. If not the wire or tube could eventually cause a permanent distortion of the foam, risking leakage.
• As long as you follow this instruction the clamp will be watertight with or without a wire/tube.
• The maximum thickness of wire/tube around which the TC clamp will seal is 1/10th inch (3.5mm).

Warning: Aquapac's warranty covers the Aquapac only, and not any items that may be put inside it.