Charger for Battery Size
2A for 6AH - 30AH
4A for 20AH - 60AH
8A for 40Ah - 160AH
Types of batteries: Most types of lead acid batteries including Calcium, GEL and AGM, Wet
Switchmode technology: Yes
Polarity protection: Yes
Output short protection: Yes
Non battery link protection: Yes
Over voltage protection: Yes
Over temperature protection: Yes
Cooling : Natural convection
Input voltage: 180-260V AC, 50Hz
Rated output: 12V DC, 2A/4A/8A
Minimum start voltage: 2.0V
The 7 stages are: Desulphation ; Soft Start; Bulk; Absorption; Battery Test; Recondition and Float.
Battery range: 6AH - 160Ah
Thermal protect : 65'C+/-5'C
Efficiency: App. 85%.
Compliant standards: CB,CE, IEC60335, EN61000, EN55014
Dimension (L×W×H): 205×90×55mm
Weight: 900g
1. Desulphation
The Desulphation stage may break down sulphation that occurs in batteries that have been left flat for extended periods of time, returning them back to full charge. sulphation occurs when lead-sulphate hardens and clogs up the battery cells.
2. Soft Start
A preliminary charge processes that gently introduces power to the battery. This protects the battery and increases battery life.
3. Bulk (Constant Current)
Bulk mode charges the battery at the maximum rate (constant current) putting a large amount of power into the battery in a short amount of time. This stage will charge the battery to approximately 80%, until the voltage reaches rated volts for 12V charger
4. Absorption (Constant Voltage)
The charge rate slows down so the battery can absorb more power and reach 100% charge. The voltage remains at a constant volts for 12V charger while the current is gradually reduced until no more power can be added without over-charging the battery.
5. Battery Test
An automatic battery test is conducted immediately after the absorption stage. The test monitors the voltage for 90 seconds to determine if the charge was successful.
6. Recondition
The battery reconditioning function is initiated automatically in the case that the battery fails the battery test (stage 5). Failing the battery test indicates that the absorption stage was unable to fully charge the battery. The recondition mode will then begin to introduce a low constant current for a period of 4 hours. Then the charger will go into float charging mode.
7. Float
The Float stage maintains the battery at 100% charge without overcharging or damaging the battery. This means the charger can be left connected to the battery indefinitely.
Output short-circuit protection
Reverse connection protection.
Correct connect for the battery, and charger works well.
AC cable length: 1.0m, DC cable with quick connector, alligator clip and O-terminal length: 1.2m, Hi-Quality alligator clip.
Related Products:car battery charger,battery charger,lithium battery charger,automotive tools
