Self Stick Silicone Door Seal Strip for Windows, Door Weather Stripping, Weather Stripping Door Seal,Silicone Sealing Tape for Door Draft Stopper Adhesive Tape(Transparent, 45mm,33Ft)

Step 1: Measure and Select the Correct Size：

-Ensure that the seal you select is slightly wider than the gap for a secure fit.

• 1.0in seals gaps up to 0.6in.
• 1.4in seals gaps up to 0.8in.
• 1.8in seals gaps up to 1.2in.

Step 2: Clean the Installation Surface

• Clean and dry the door or window frame where you will apply the weather stripping.
• Remove any dirt, dust, grease, or moisture from the surface to ensure strong adhesion.
• Note:If the surface is not thoroughly cleaned, the adhesive may not stick properly, leading to peeling or reduced effectiveness.

Step 3: Measure and Cut to Fit：

• Unroll the weather stripping and measure the length you need for the door or window.

Step 4: Apply the Seal

• Peel off the adhesive backing slowly, starting from one end. Align the seal with the edge of the door, window, or frame.
• Note:If you're installing the seal in cold weather (below 50°F/10°C), use a hair dryer to warm the adhesive slightly before applying. This helps the adhesive stick better in low temperatures.

Step 5: Trim Excess and Final Pressing

• After applying the seal, trim any excess material with scissors to ensure a clean and flush fit.
• For better adhesion, you can press firmly with your fingers or a soft cloth.
• Additional Installation Tips:-By following these steps and choosing the right door or window type, you will enjoy long-lasting protection,
• For corners and curves: If you're sealing around a window or door with curves or corners, carefully align the seal along the contour and press firmly to prevent any gaps.
• Temperature considerations: If you must install the seal in colder weather, always warm the adhesive as mentioned in Step 4 to ensure a secure bond.
• Wait before testing: Allow the adhesive to bond for at least 12-24 hours before testing the door or window to ensure the best performance.