Instructions
. Painting Conditions: Use outdoors or in a well-ventilated area such as an open garage. Use when temperature is above 50°F (10°C) and humidity is below 85% to ensure proper drying. Do not apply to surfaces that exceed 200°F (93°C). Avoid spraying in very windy, dusty conditions. Cover surrounding area to protect from spray mist. Preparation: Clean area to be primed with Mineral Spirits to remove all oil, grease wax and dirt. Dry thoroughly. Lightly sand the surface with #400 wet or dry sandpaper. Keep sandpaper wet by soaking it in water while sanding. Wipe the sanded surface clean when finished. Priming: Shake can vigorously for one minute after mixing ball begins to rattle. Shake often during use. Hold can 12-16” from surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface and in motion while spraying. For the best adhesion, apply 2 to 3 thin coats and allow each coat to dry for 2 minutes before applying the next coat. Allow final coat of Self Etching Primer to dry for a minimum of 3-4 hours before dry sanding, or 15 minutes before wet sanding, with #400 sandpaper. Note: Self Etching Primer features an advanced spray system that allows you to spray at any angle, even upside down for those hard to reach areas. A comfort spray tip with wider finger pad reduces fatigue caused by continuous spraying. Dry & Recoat Times: Dries to touch in 10 minutes and dries to handle in 15-30 minutes at 70°F (21°C) at 50% relative humidity. Top coat after 30 minutes. Allow more time at cooler temperatures. Clean-up: Clean up wet or dry paint with Xylol. Mineral Spirits can also be used to remove wet paint. Throw away empty can in trash pickup. Do not burn or place in home trash compactor. Clogging: If valve clogs, twist and pull off spray tip and rinse it in a solvent such as Mineral Spirits. Do not stick a pin or other objects into the stem.
Safe Handling Instructions
DANGER! EXTREMELY FLAMMABLE. VAPOR HARMFUL. VAPORS MAY CAUSE FLASH FIRE. CONTENTS UNDER PRESSURE. WARNING: CONTAINS TOLUENE, ACETONE AND XYLENE. VAPOR HARMFUL. MAY AFFECT THE BRAIN OR NERVOUS SYSTEM CAUSING DIZZINESS, HEADACHE OR NAUSEA. CAUSES EYE, SKIN, NOSE AND THROAT IRRITATION. NOTICE: Reports have associated repeated and prolonged occupational overexposure to solvents with permanent brain and nervous system damage. Do not breathe vapors, spray mist, sanding dust or overspray. To avoid breathing vapors or spray mist, open windows and doors or use other means to ensure fresh air entry during application and drying. If you experience eye watering, headaches or dizziness, increase fresh air or wear respiratory protection (NIOSH/MSHA approved) or leave the area. Follow respirator manufacturer's directions for respirator use. Avoid contact with eyes, skin and clothing. VAPORS MAY IGNITE EXPLOSIVELY. Keep away from heat, sparks and flame. Extinguish all flames and pilot lights, and turn off stoves, heaters, electric motors and other sources of ignition during use and until all vapors are gone. Do not smoke. Use only with adequate ventilation. Prevent build-up of vapors by opening all windows and doors to achieve cross-ventilation. Do not expose to heat or store at temperatures above 120°. Exposure to heat or prolonged exposure to sun may cause bursting. Do not puncture or incinerate (burn) container. Replace cap after each use. FIRST AID: If you experience difficulty in breathing, leave the area to obtain fresh air. If continued difficulty is experienced get medical assistance immediately. In case of eye contact, flush immediately with plenty of water for at least 15 minutes and get medical attention. WARNING: This product contains chemicals known to the state of California to cause cancer and birth defects or other reproductive harm. KEEP OUT OF REACH OF CHILDREN. INTENTIONAL MISUSE BY DELIBERATELY CONCENTRATING AND INHALING THE CONTENTS MAY BE HARMFUL OR FATAL. DO NOT STORE ABOVE 120°F.
WARNING: 
