Klein Tools Screwdriver #2 Phillips,1/4" Slotted

[This review was collected as part of a promotion.] If you hate Klein's traditional multi-drivers, due to worries about bits falling out, play in the handle and bits, and the thick shaft, preferring the thin, solid shaft of the fixed blade drivers, you might love one of these! I'd never seen one before, and was very surprised by how rock solid the mechanism for holding the blades are; There is absolutely 0 play between the shaft and handle when inserted properly, and even holds up to high torque use and being used as a chisel (Though be careful of that, you've only got about half an inch of plastic on the bottom-- it will definitely break if you're rough enough on it) Additionally, I didn't realize how valuable the adjustable blade would be; being able to extend out to 8 inches has made a lot of situations a lot easier to work in. Another perk of this is it'll hold any 1/4" bit with atleast 2 inches of hex shaft without any issue. I normally carry around Klein's drill mounted conduit reamer, along with an extension and a few uncommon bits and just swap them out with the blade as needed, letting me carry a lot of options with one screwdriver handle. Also, made in the USA! Unlike a lot of Klein's newer screwdrivers... I feel like this screwdriver was somewhat abandoned by Klein-- Your only other options for blades are a #1 phillips and flathead, or a 1 and 2 robertson. More options on that front, along with some other 1/4" bits to use in it would be great.