Brock Replacement Drivers Power Sliding Door Roller Compatible with 99-04 Odyssey EX EX-L Center Rail Male Roller 72560-S0X-A53 72561-S0X-A51 72560S0XA53 72561S0XA51

Driver's side Power Sliding Door Roller

FEATURES
- EXCLUDES Hinge/Cover

Fits on Male Roller Left Center Rail Position

FITMENT
Honda Odyssey (EX and EX-L models ONLY) 1999 2000 2001 2002 2003 2004

TIPS for Replacing your Sliding Door Roller
- The Roller assembly is located behind the sliding door.
- The rail cover houses the sliding door roller assembly.
- In order to remove the rail cover, the tail light assembly must be removed first.
- Press the door OPEN button and turn door switch OFF from control panel (left of steering wheel).
- Remove screws on small body panel which covers the cables and pull off body panel cover.
- The rail/body panel slides back about 2 inches and then pulls off exposing the cables.
- To mark alignment, use a felt pen to trace around where the roller assembly mounts to the inside of the door.
- Remove or at least pull back the interior side panel slightly (located between sliding door and trunk).
- This is necessary in order to loosen the door drive cable inside the car enough to remove the cables from the rollers.
- Unhook the cables and remove old roller. Install new sliding door roller.