Valken "The Unit" Fill Station

Solid billet aluminum body: No sheet metal to dent, corrode or need repainting. CNC machined air passages: Never worry about blown internal hoses or leaking fittings again. No moving o-rings: Sick of replacing all those o-rings on your push button? 1 single easily replaced delrin seal: add an "upstream" 10 micron filter and wear is practically a non issue. Fill lever along with all internal components are made from stainless steel: Incredible duty cycles are achieved, far greater than a plunger style. Valve "Cartridge" is fully sealed yet easily removed if needed: Virtually guarantees no particulate can enter and cause a leak (don¹t forget the "upstream" filter). All holes use a standard thread 3/8-16: Precise cnc holes & threads. No lubrication design: Use it and put it away, ever think you’d hear that? Front & side air outlets: Run your air lines the way its best for you. 80% less force required to activate: One finger will get your customer a fill, no more table buckeling leans.Brushed stainless steel gauge shroud: Keep the high quality liquid filled gauge functional for years. Filtered rear exhaust: Silent & efficient.H.P. inlet from the rear: Everything is above board, no more under table plumbing needed.10 seconds rebuild: If you choose to not utilize an in-line filter & develop a leak just unscrew the cartridge, "drop in" a new delrin seal. your back up & running in seconds..“The Unit” consists of an unregulated fill station with quick fill handle and gauge. It takes 1/4” NPT inlet and serves a 1/8” NPT outlet to whip. It does not come with any connections or hoses.