"
LED Headlamps
Plug Type: 9005 (High Beam) + 9012 (Low Beam) + 9006 (fog light)
Power:100W/set(50W/bulb)
LED Quantity(each bulb): 2pcs* COB Chips
Luminous Flux:11000LM/set(5500lm/bulb)
Operating Voltage: DC 9-32V(fit 12V,24V vehicles)
Color Temperature: Ice blue 8000K
IP65 rated water and dust seal,360 degree beam angle
Material: Aviation 6063 aluminum profile
Operating Temperature: -40-80 degree Celsius
Over 50000 hours life time
Usage: High + Low Beam Headlight + Fog Light Combo
(6pcs/set)9005+9012+9006 COB LED headlight conversion kit
Super bright COB chip,360 degree clear beam no blind zone
Engineering beam pattern design throw light on road evenly at appropriate angle
without foggy light
All-in-one heat conduction+high speed mute fan system keep the light bulb in
appropriate working temperature
Built-in constant current CPU,instant full brightness without start-up relay
Two-way heat dissipation chiannel
1.All-in-one aluminum profile as heat conduction system,360 degree heat radiating
2.High speed mute fan(12000R/Min),high Air flow for faster cooling rate
Package Included:
2x 9005 LED headlight bulb
2x 9012 LED headlight bulb
2x 9006 LED Fog Light bulb
Notes:
1. For Chevy Silverado 2001-2007, the factory brackets for the adjustment screws won't allow the back cooling fan of the bulb to fit. You need to cut headlight support brackets to make the bulbs fit.
2.For Dodge RAM vehicles, when installing these headlights, you need to drill a hole on dust cover for the cooling fan. It's also OK if you don't use dust cover, cause our led bulb is waterproof and dust proof.
3. For Dodge, Jeep, Chrysler, after install our LED Headlight bulbs, if the bulb flicker or have error code, you can buy a decoder resistor to solve it
Install Caution
1. As a safety precaution, make sure that the car has had time to cool down properly before starting the installation process.
2. Put the vehicle into park or make sure it is securely in gear.
3. Make sure to have the ignition turned off and the keys removed.
4. Be careful to avoid burns, especially when turning on or off the vehicles lighting.
5. Be careful to avoid crushing or cutting the bulbs. Also make sure to not touch the bulbs with your fingers, as this will cause blotting.
6. Fully examine the connection of the contact points, ports and the wires as faulty connections can cause lighting problems.
7. Make certain that the end of the bulb does not come in contact with the interior light shield of the headlight when adjusting the bulb.
"
