Winjet LED Tail Lights Fit For 1997-2003 Ford F150 & 1999-2007 Ford F250/F350/F450/F550 Super Duty Taillight Assembly w/LED Turn Signal/Running/Brake Light (Black Housing Smoked Lens)

【Perfect Compatibility】This LED tail lights fit for 1997-2003 Ford F150 (Excluding 4-Door SuperCrew Cab Models), 1997-1999 Ford F-250 Light Duty (7 Lug Nut), 2004 Ford F150 Heritage (Excluding 4-Door SuperCrew Cab Models), 1999-2007 Ford F-250 F-350 F-450 F-550 Super Duty, Only Fits Styleside Models, DO NOT Fit Flareside Models. Please make sure your vehicle in our match list before purchased.

【Latest LED Lighting Dot Matrix Design】The Running Light / Brake Light / Turn Signal Light of this taillights adopts a special cool LED dot matrix lighting layout. The new and special LED lighting layout design not only makes your vehicle more distinctive and attractive on the road, but also provides clearer and brighter indications for the vehicles behind you, fully guaranteeing your safety.

【Excellent IP67 Waterproof】 Made of high quality OEM Grade ABS plastic and processed with waterproof coating, UV filter coating and shockproof coating, etc., which has good sealing and could reach up to IP67 waterproof. It can resist all kinds of bad weather, prevent the damage of taillights caused by rain, snow, dust, gravel, etc., and effectively prolong the service life of the product.

【DOT & SAE Compliance】 All taillights assembly of Winjet are lab and vehicle tested to ensure compliance with US DOT & SAE policies and other international regulations.

【Easy Plug & Play】Direct-Fit and Plug & Play. No Rewiring or Modification on the Original Circuit Needed. If you need any installation guidance, please kindly contact us at any time, we would provide you with reference.

How to Install
1. Open the box and inspect the item. Verify what was received was what you ordered and that the item is free from physical damage or defect.

2. Remove the old tail light. First thing you have to do is undo the mounting screws on the outside, if there’s any. You’ll have to open the trunk or any rear door or opening on the vehicle to access the back of the tail light. The wiring harness must be disengaged from the assembly through its back.

3. Once the wiring harness is out, you can now undo the mounting screws or nuts, whatever fastener is used. With no more screws or nuts holding it in place, you can push out the assembly from behind. Check if the tail light assembly you just removed is the same as the new one.

4. See if they have the same components, design, and fasteners to ensure proper fitting. Fix the new assembly into the tail light pocket. Once it’s fitted into place, secure it with the screws or nuts. Tighten them properly. You can now plug in the wiring harness that you removed earlier.

5. Test the new assembly. Switch on the tail lights to see if they work. If not, then some adjustments should be done to the newly installed tail light kit. Put back any cover, trim, or component that was removed to access the tail light assembly.