Armor All Ultra Shine Headlight Restoration Wipes, Automotive Headlight Restorer, 6 Count

The product comes with 4 oxidation removal wipes and 2 UV Sealant wipes, enough for two headlights. The temperatures have been at or below 40 degrees, so I researched whether it would be affected by the low temperatures. My research confirmed what it said on the box, that low temperatures or high humidity would make the UV Sealant take longer to dry (normally 3 hours). My passengers headlight looked like the BEFORE picture on the box. I was afraid that it was fogged up inside rather than oxidation. Before I started I taped around the headlight with painters tape, as they recommend because the Oxidation Removal Wipes will damage the paint. Following the warnings of skin contact, I wore plastic painters gloves. I used 2 oxidation removal wipes and could see it improving as I worked. The directions don't mention how long to wait before using the UV Sealant, so I waited a little over an hour to make sure the headlight was dry from the oxidation removal. I applied the UV Sealant and checked a number of hours later. The Sealant was dry and the headlight looked like new.

I had the opportunity to pick this as a sample for review. To be honest, I was a little skeptical at first. I've never used this product before and I didn't know how it was going to restore my car's old headlights. When I received the product, the box contained 6 packs of wipes. There were four of them labeled "step 1" (you will use 2 per headlight). There were two of them labeled "step 2" (you will use 1 per headlight). The entire process took me about 30 minutes (15 min per headlight). Also, they recommend 3 hours drying time afterwards. So pick a sunny day to do this. The directions were fairly simple: Step 1 - take the wipe out of one of the step 1 packs and apply it on the headlight. The instruction says keep applying and rubbing until the residuals lighten up. It also says do it at least 2 minutes and change to another step 1 pack wipe. This time, do it until no more residues on the wipe. My tip here is start with one corner and go around the edges first and make a complete circle. Then work on the center. The wipes are already folded when you open them. But I folded it one more time to make it smaller and easier to handle. After I finish one round, I would use the other side of the wipe. Anyhow, it seems it took me about 6-8 rounds per wipe. Each time, you'll see a haze on the headlight. Just don't get discouraged and keep at it. I will finally clear after using both wipes. And then, I applied the step 2 wipe (which is a sealer). And like magic, your headlight will almost look brand new....really shiny! I couldn't believe it. Anyhow, I've included the pictures here. I think they speak for themselves. I am so pleased with this product, I'm going to buy another box and do this on my wife's car. Definitely would recommend to a friend!