Spa Choice Chlorine Granules for Spas and Hot Tubs, 5 lbs.

Spa Choice Sanitizing Granules are designed to dissolve quickly and completely. Chlorine granules provide a steady source of available chlorine to spa water to control algae growth, kill bacteria and destroy organic contaminants. Spa choice chlorine granules are stabilized to protect against ultraviolet radiation from the sun, increasing the life of your chlorine. This product is designed to dissolve quickly and completely providing a steady source of available chlorine to control the growth of algae, kill bacteria and destroy organic contaminants. DIRECTIONS FOR APPLICATION: Broadcast the product evenly over a wide area in the deepest part of the spa with water circulating. F DIRECTIONS OR SPA AND HOT TUB USE: Each level teaspoon (0. 17 ounces) of this product will provide approximately 1. 4 ppm available chlorine in 500 gallons of water. Using an appropriate test kit, test and adjust the water to the following values: pH 7. 2-7. 8, total alkalinity 60-100 ppm, calcium hardness 200 ppm minimum. Maintain these conditions for proper spa and hot tub operation by frequent testing with a test kit. Do not allow cyanuric acid level to exceed 150 ppm. It is recommended that spas and hot tubs be drained every 3-90 days. More often under heavy use. Consult manufacturer’s recommendations concerning the compatibility of chlorine sanitizers with their equipment. Some oils, lotions, fragrances and cleaners may cause foaming or cloudy water and may react with chlorine sanitizers to reduce their efficacy. DIRECTIONS FOR START-UP (FRESHLY FILLED) 1. Turn on the circulation system and ensure that it is operating properly. 2. Add 6 teaspoons of this product for each 500 gallons of water. Check the free available chlorine (FAC) and, if below 4-5 ppm, repeat as needed. Re-entry into treated spas is prohibited above levels of 3ppm of chlorine. DIRECTIONS FOR REGULAR USE: Turn on the circulation system and ensure that it is operating properly. Scatter approximately 3teaspoons per 500 gallons of this product over the surface of water. Always use a clean dry spoon. Test for FAC and add additional product, if necessary, to attain 4-5 ppm FAC. Maintain 1-3ppm FAC while the spa or hot tub is in use. After each use, shock treat with 9 teaspoons per 500 gallons water to control odors and algae. Repeat as needed. Re-entry into treated spas is prohibited above levels of 3ppm of chlorine.