Solarera Solar Deck Lights Fence Post Solar Lights for Patio Pool Stairs Step and Pathway, Weatherproof LED Fence Lights Solar Powered Outdoor Lights, White 12Pcs

【Automatic Turn ON】 The step light has no switch, and can be put into use by pulling out the insulating sheet. The built-in light sensor can automatically charge during the day and open at night.

【Long Working Time】Upgraded recharge wider solar panel and 10 lumens per light will be much brighter. The solar panel is bigger. It only takes about 4-5 hours to charge fully on a sunny day. It can work for about 10 hours.

【Easy to Install】 Without wires, you can use the screws or tape in the package to lay it flat along any edge of stairs, decks, fences and steps.

【Waterproof and Durable】 The solar deck lamp is made of durable ABS plastic, and the solar panel is sealed with waterproof glue, with a waterproof grade of IP65, which can work normally even after a storm. The service life of LED is up to 10000 hours.

【Widely Used】 Solar fence outdoor lighting is very suitable for illuminating stairs, paths, gardens, decks, front doors, backyard, driveways, garages, outdoor walls, etc.

Adhesive Installation Method:
1. Clean the surface of the step where you plan to install the solar step lights, ensuring it is dry and free of any dirt or debris.
2. Apply a generous amount of strong adhesive to the back of the solar step light, following the manufacturer's instructions for the specific adhesive you are using.
3. Press the solar step light firmly onto the desired location on the step, ensuring it is level and secure.
4. Allow the adhesive to dry completely, following the recommended drying time provided by the adhesive manufacturer.

Screw Installation Method:
1. Using a screwdriver, or optionally a drill with an appropriate drill bit, create pilot holes on the step surface where you want to install the solar step lights. The pilot holes should be slightly smaller in diameter than the screws.
2. Align the holes on the back of the solar step light with the pilot holes on the step.
3. Insert screws through the holes on the back of the solar step light and into the pilot holes on the step.
4. Using a screwdriver or drill, tighten the screws until the solar step light is securely attached to the step. Take care not to overtighten and damage the light or the step.

Specifications：
Material：ABS+Polycrystalline Silicon
Light Color: Multicolour/Yellow/White
Rated Power: 2W
Whether to Switch Automatically: Yes
Waterproof Level: IP65
Charging Time：4-5 Hours
Lighting Time: 10 Hours
4-Piece Weight：220g/0.49lb
Size：9.2×6.5×9.2CM/ 3.62×2.66×3.62 Inches

Basics 4-Piece Package：（8, 12, 16, 20-Piece Packs are multiples of 4-Piece Packs.）
4 x Solar Step Lights
4 x Double-sided Tape
8 x Screws