Shurtape VP-410 Vinyl Film Tape: 2 in x 36 yds. (Yellow) *branded

Shurtape VP-410 Vinyl Film Tape is a tough tape for tough jobs. VP-410 is versatile, long-lasting, resistant to weather, abrasion and wear. Highly conformable and easy to apply, Shurtape VP-410 is engineered with a non-corrosive adhesive and flexible backing. The tape is UV (ultraviolet) resistant and can be used in extensive temperature (20 F to 140 F), moisture and humid conditions and environments. Shurtape VP-410 vinyl film tape is a smart choice for general purpose floor, lane and aisle marking, color-coding and identification applications, as well as in the HVAC industry to wrap line sets, seam Rubatex and Armaflex, and insulate air ducts and underground pipes. This tape meets OSHA color-coding requirements, applicable standard CID A-A-1689B, Type 1, Class 2, and is available in a wide range of colors and widths.

NOTES: Sizes shipped will typically be the tape industry standard metric-cut sizes, i.e. 24mm for each 1 inch of nominal tape width ordered (rolls are approximately 5% narrower than the nominal size). This product's actual size is 50mm wide. This tape is typically cut to width from log rolls so most sizes ship on non-branded plain white cores. As with any adhesive tape product it is always the user's responsibility to determine that the product is suitable for their intended use; e.g. if you want to remove a product cleanly from a specific type of substrate please test on an inconspicuous area first. Warning: This product can expose you to chemicals including Di(2-ethylhexyl)phthalate (DEHP), which is [are] known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov/.

Technical Information
- Core: 3 inch diameter neutral
- Backing/Carrier: soft polyvinyl chloride (SPVC) film
- Adhesive: natural rubber
- Standards Met: CID A-A-1689B Type I Class 2 (canceled PPP-T-66E Type 1 Class 2)
- Thickness: 5.25 mils (carrier, adhesive)
- Adhesion: 20 ounces per inch (to stainless steel test panel)
- Tensile Strength: 13 pounds per inch (longitudinal)
- Service/Operating Temperature: 20F to 140F
- Elongation: 200 %