MFM Peel & Seal Self Stick Roll Roofing

The MFM Peel & Seal Self Stick Roll Roofing is the original, patented self-stick roll roofing. Peel & Seal roll roofing is 33 feet 6 inches long and is ideal for roofs and surfaces that are difficult to waterproof and can be used on many surfaces including metal roofs, mobile homes, RVs or trailers, and sunroofs. This rolled roofing can also be used as flashing around ducts, vents, chimneys, air conditioning units, or even gutters.

MFM Roll Roof Peel & Seal self-stick roofing is made of aluminum composite foil, polymer films, and a rubberized asphalt adhesive back, making it flexible and self-adhering. Peel & Seal roll roofing will not tear, crack, or dry out over time. It is designed to reflect heat and resist water and exposure to other elements without additional coverage. Peel and Seal can be installed on an EPDM roof, but you must prime it with WeatherBond Multi-Purpose Primer or Mule-Hide Tape Primer.

This self-adhering rolled roofing is straightforward to install. Simply ensure your surface is clean, smooth, dry, and loose debris-free. Be sure to prime your surface with an asphalt primer before applying Peel & Seal self-stick weatherproof roll roofing, especially on weathered surfaces made of plywood, OSB, composition board, and masonry. New plywood surfaces do not require primer. After the roof is prepped, you will simply peel off the release paper on the back of your Peel & Seal, and roll it out onto your surface, using a hand roller to smooth out any creases. Finally, use a sharp knife to cut off the desired length. All 36-inch rolls will feature blue guidelines three inches from the edge, to assist with overlapping during installation.