HB4 9006 For Buick Regal 1990-2004 LED Headlight Bulbs Low Beam 11000LM 6000K White

Notes:
1. Please check whether it is fit your vehicle before purchase.
2. This item is compatible with universal vehicles: Car, SUV, ATV, VAN, Pickup Truck, Bus, Wagon, Motorcycle etc. (Please confirm plug type of your vehicle,Thank you! )

Specifications:
Socket: 9006/HB4
Beam Angle: 360 Degree
LED Chip: COB LED Chip
Waterproof: IP67
Type: Plug And Play
Working Temperature: -40-150 degree
Color Temperature: 6000K Super White
Voltage: DC 9V~32V, built in IC driver, much more stable than normal LED bulbs, longer lifespan.
Current: 950±30mA
Material: Aluminum Body
Lumens: 5500 lm per Bulb
Lifespan: ≥50,000 Hours
Usage: Headlight
Note:For a few newest years make cars(About 0.1%) And DRL Model may need add Load Resistors(Not including) to stop flickering Issue or fix error message )

Package Included:
2x 9006/HB4 LED Light Bulbs
Well Packaged in Retail Box

LED headlight advantages:
1. LED lamps are more energy and power than conventional halogen lamps.
The brightness is close to the xenon lamp, but the LED lights are illuminated without delay to enhance road safety.
Instantly start without strong current impact, improve battery life by more than 30%.
2. Fast cooling , using the most advanced, heat-dissipating structural design.
Low warranty:
The power driver adopts a wide voltage constant current mode which has a simple structure, so that the automobile can flexibly cope with various voltage unstable conditions, and has achieved the purpose of less component damage. Compared to HID ballast maintenance, The repair probability is very low which is less than 80%.
3. Low heating temperature, The working temperature of helium can reach 800°-1000°
4. LED headlight has a simple structure, and the parts are less than the xenon lamp, which is lower than the xenon lamp failure rate!
5. Car LED headlight color temperature are balancing. Xenon bulbs are clear in the same color, about 6000K.

Install Caution
1. As a safety precaution, make sure that the car has had time to cool down properly before starting the installation process.
2. Put the vehicle into park or make sure it is securely in gear.
3. Be sure to turn off the ignition and remove the key.
4. Be careful to avoid burns, especially when turning on or off the vehicles lighting.
5. Be careful to avoid crushing or cutting the bulbs. Also make sure to not touch the bulbs with your fingers, as this will cause blotting.
6. Fully examine the connection of the contact points, ports and the wires as faulty connections can cause lighting problems.
7. Make certain that the end of the bulb does not come in contact with the interior light shield of the headlight when adjusting the bulb.