BODY ARMOR 4X4 Pro Series Rear Bumper, Black, Tacoma TC-2963 Fits select: 2016-2020 TOYOTA TACOMA

Very nice bumper great quality

Great looks and went on easily. BA includes enough spacers to get the gap right on a truck with a factory hitch. Took 3 hours to mount including getting wiring undone and removing the factory bumper. Removal being 2/3 of the time. I literally needed a buddy to help lift this for like 2 minutes to get the main hardware attached to the frame. Alignment went smoothly and I only stripped one allen bolt head over tightening with a driving tool. My fault but it was in and I will not fret about it unti I need to remove it, if ever. Only complaint, I needed to "find" wire length to attach my hitch wires. This is due to manufacturing by Toyota. I read that some people had enough and some didn't. What I did was take the loom off and pop some factory clips off (including the 90 degree clip at the back of the factory plug) and pull to the new location. I ended by using rubber lined wire clamps to reattach the harness. To their credit, Toyota wiring is tight with little waste. It would have been nice if the hitch cutout followed the contour of the angle where the plate lights are or even make the license plate area 2 inches wider. I love the look of it and would bet it is actually pretty freaking hard to bend which is why I have it. Toyota didn't give us a real bumper. I went a bit further and installed flush mount cube lights which did require some drilling but look so much cleaner than the alternative.