Headliner Installation Tips -Not Glue inclued
Step 1: First you need to remove the sagging Headliner;
Step 2: Find a good, large, clean area to work lay the headliner face up on the table Nest, spray the strong glue on the strip about 6" wide down the middle of the headliner, have a friend hold the materials up above the headliner while you use the plastic paint guide to smooth the materials on to the glue. After a couple of minutes, pull the materials back so that you can spray one of the sides that dones not yet have glue on it, Spray the adhesive, and repeat the process of smoothing. continue with this until the fabric has been glued down on the entire surface of headliner;
Step 3: After the glue has a night to set up, turn the headliner over. Cut some slits in the fabric to make it easier to wrap around the edge and, run a head of glue along the edge of the headliner and fold the fabric over and press it down. Try to make the fabric conform as closely to the edge as possible;
Step 4: Cut holes in the fabric for the dome light, sun visor and the clips that hold it up, replace the headliner.
Note:
1. The roof liner fabric is folded for delivery, not delivered in rolls. Used a dish towel and a steam iron to remove wrinkles from being folded during shipping.
2. Just measure the length and width of your vehicle's headliner to make sure you order enough material to recover it. If you need other size, pls contact us first.
Tips: Suggesting slightly larger size!
3. Normally when customer places 2 or more quantity we combine the size and ship them together as one continuous. (If you purchase 2 Qty 54"x 60", we will send you one piece 108"x 60"). Pls open the parcel and measure the item size. Please contact us at any time for any issue.
WARNING: 
