Delta Pivotal Soap/Lotion Dispenser, Arctic Stainless

When I pushed the soap dispenser handle down, soap leaked from the dispenser. The leak is due to a missing O ring in the soap dispenser handle. Delta replaced the entire soap dispenser though an O ring was all that was needed. I think there is a problem with the handle design. It's heavy and the O ring is less than 1/8 inch in diameter. You can expect to support a heavy handle that on a small O ring. I recommend that customers who own the RP91950AR dispenser cut their soap solution with water (1 part of soap + 1 part of water). I also recommend that customers periodically remove and clean the handle. Be careful to not remove or damage the O ring. If you do, the dispenser will leak.

The soap pump matches with my faucet and worked well for this first six months. Since then, I noticed that soap has been leaking out of my holder and getting under my sink messy. I tried to re-tighten it and noticed there's no O-ring or seal that was included with the kit. Also, the threaded pipe going down from the pump to the bottle is a cheaper plastic and is cracked. I have been trying to stop the issue of leaking for a long time, and just started using a regular bottle of dish sap by the sink, which was not the look I was going for. I have also noticed that where the soap comes out of the pump has tarnished, even though I expect it will not continue to the top side I am concerned. Also it has a jagged edge from when Delta drilled the whole. After getting a small cut, I learned not to put my hand to close to the opening. After writing this review I realized that the two stars was actually, too high and reduced it to one. I do appreciate the sleekness of the design though.