AcuRite 01598A1 12.5-Inch Wall Thermometer, Bluebirds

We apologize if your thermometer is reading inaccurately, but we are happy to assist! Analog thermometers may need to be calibrated from time to time or even just after purchasing the product. The pointer may move during shipping, causing the thermometer to read inaccurately. These steps can be used on analog, bi-metal coil thermometers. Calibration: If the thermometer is reading incorrectly, compare the reading to a known accurate thermometer. Let both units adjust for at least three hours. Depending on the product, there may be a knob or screw on the back of the thermometer to calibrate the temperature. If the new thermometer continues to read inaccurately, adjust the pointer by turning the knob or screw on the back of the unit in the appropriate direction. If there is no knob or screw for calibration, you will need to adjust the pointer by hand. If the temperature reading is too low, slowly push the needle up to the highest temperature and then slowly let it follow your finger back down until the needle stops on its own. Never let the needle swing back wildly on its own, as this can permanently damage the thermometer. When the needle stops, it will stop a degree or two higher than where it was originally set. Repeat this process until the needle stops at an accurate temperature reading. If the thermometer is too high, push the needle down to the lowest temperature instead. NOTE: While most thermometers can be easily disassembled to gain access to the pointer, some thermometers may not allow easy access to the pointer. Disassembling may damage the thermometer or void the warranty and is not recommended. NOTE: These instructions are to calibrate temperature but can also be used to calibrate humidity. If this does not correct the issue, please reach out to our support team via live chat or email request on the AcuRite Support website.Have an outstanding day!HayleeAcuRite Support Team