Speedster Swept Exhaust - Chrome , Color: Chrome

• Grab some attention with these deep rumbling pipes
• For increased low and mid-range power the Cobra Power Port is included
• 1-3/4 inch head pipes, full-length 2-3/4 inch heat shields to give the pipes the correct look are included
• Heat shields will not discolor
• Removable power cores
• Made in the U.S.A.

Note: System includes oxygen sensor bungs

Includes the following:
(1) Front Headpipe
(1) Rear Headpipe/Heatshield
(1) Exhaust Mounting Bracket
(1) Muffler Assembly
(1) Exhaust Valve Actuator Bracket
(1) Exhaust Valve Actuator Solenoid Cam
(5) HS 24 Clamps
(4) HS 32 Clamps
(2) 27-61 Clamps
(2) Aluminum Spacers
(2) Flat Washers (1/4 inch and 5/16 inch)
(2) 6mm x 50mm Bolts
(2) 6mm Nuts
(2) 5/16 inch Nuts
(4) 5/16 inch x 5/8 inch Flange Bolts
(2) 1/4 inch-20 x 3/8 inch Bolts

Installation of a new exhaust system may change your motorcycle's fuel-air mixture requirements. Please consult the exhaust manufacturer directly with questions regarding any modifications that may need to be made during, or after, installation of their product. If a jet kit or EFI controller is recommended, see the Intake & Fuel section

Exhaust discoloration (bluing) is caused by engine conditions such as cam timing, fuel-air mixture, operating temperature, etc. It is not the result of defective manufacturing; therefore is not covered by any warranty. See Chems & Lubes section for products that will help prevent or remove bluing.