JEGS Open-Wheel Long Tube Weld-Up Header Kit Primary O.D. 2 1/8 in. & 4 in. Collector

Open-Wheel Long Tube Weld-Up Header Kit

Primary Tube 2 1/8 in. O.D.

Collector 4 in. O.D. x 9 1/2 in. L

Made in the USA

Universal Kit Includes:

(4) Right Passenger Side Primary Tubes

(4) Left Driver Side Primary Tubes

(2) Primary Tube Weld Tabs

(2) Collectors

Note:

Cutting and welding is necessary to install this Universal kit, and modifications to the primary tubes may be necessary to fit your application. You will also need to purchase the proper block plates (3/8 in. thick recommended), gaskets, fasteners, and other items not included in this kit.

For a listing of JEGS Header Flanges Click Here:

For a listing of JEGS Header Gaskets Click Here:

For a listing of JEGS Header Bolts Click Here:

Primary Tube Length(before bending)

Cylinder Length 1 & 2 38-5/8" 3 & 4 40" 5 & 6 37-1/2" 7 & 8 39-1/2" Special Exhaust Headers Notes:

Due to variations in engine and vehicle configurations, installation of aftermarket headers may require minor modifications

Common adjustments include power-steering or A/C bracket relocation, dipstick tube modification, or clearance for steering shaft and clutch linkage

Inspect for worn or collapsed motor mounts, and verify clearance for spark plugs, wires, brake lines, and transmission or fuel lines

Always test-fit headers before painting or coating to ensure proper alignment and clearance

Re-torque after initial heat cycles

Emissions Note:

This part is only legal for sale and use on Uncontrolled (Non-Emissions Controlled) Vehicles or on vehicles used solely for the purposes of closed competition racing.

CLICK THIS LINK FOR IMPORTANT CARB & EPA EMISSIONS INFORMATION ABOUT THIS PART