Toyota MATRIX 44D DOT Chip Key + 3 Button Remote GQ43VT14T + Programmer VLS

Smart and efficient. Program a transponder key in about 20 seconds! No 30-minute wait, and no pin codes. Just connect to the OBDII port and go. Simply the fastest way to program TOY44D keys

Compatibility with the following:

2005-2008 Toyota Corolla

2005-2008 Pontiac Vibe

2005-2008 Toyota Matrix

OE: 89742-AA030

FCC ID: GQ43VT14T

Frequency: 315 MHz

Battery: CR2032

Buttons: Lock, Unlock, Panic

Toy44D Transponder Key

Chip: 4D67 (Master)

Test Key: TR47

Cross Reference: TOY44D-PT, 5910834, 89785-08020, 89785-60160

Programming Instructions:

To program keys when all keys have been lost:

1. Using the transponder master key, switch the ignition to the “ON” position

2. Insert the tool into the OBDII port. You will hear one beep. After about 3 seconds, tool will beep 3 more times indicating that the vehicle has been placed into programming mode.

3. Remove the tool and the key.

4. Perform the following steps to program the keys: a. Close all doors b. Insert the first master key for 5 seconds (do not turn) c. Insert the second key for 5 seconds (do not turn) d. Insert the valet key for 5 seconds (do not turn) e. The programming mode should automatically end. If, for some reason, you need to end programming mode manually, simply insert and remove the first master key 5 times (do not turn).

To program additional keys when you have one working master key:

1. Using the working master key, switch the ignition to the “ON” position

2. Insert the tool into the OBDII port. You will hear one beep. After about 3 seconds, the tool will beep 3 more times indicating that the vehicle has been placed into programming mode.

3. Remove the tool and the key.

4. Perform the following steps to program the keys: a. Close all doors b. Insert the first master key needing programming for 5 seconds (do not turn) c. Repeat step B for each key needing programming d. Insert and remove the original master key 5 times (do not turn) to end the programming

Programming instructions:

Start by sitting in the car with the key out of the ignition, Open the driver's door. (step 2 and 3 have to be done within 5 seconds)

Insert the key into the ignition and Pull it out

Perform these steps within 40 seconds. The driver's door is still open.

Close the driver's door and open the driver's door.

Insert the key into the ignition and Pull it out

Insert the key into the ignition and leave it in the ignition.

Close the driver's door.

Turn the ignition to the “ON” position and then to the “OFF” position.

Pull out the key from the ignition.

** The power door locks should lock then unlock so you are in programming mode and ready to program the remotes. If this does not happen start again**

Remote programming has to be done within 40 seconds.

Press both the lock and unlock buttons on the remote for about 1 and 1/2 seconds then let go

Press the lock button for 2 seconds and let go. The car doors should lock and unlock. If they do then you are ready to program the next remote.

Open the driver's door to end programming mode.