EKWB EK-Quantum Vector FE RTX 3070 Ti D-RGB GPU Water Block, Special Edition, Silver

This Special Edition Vector water block directly cools the GPU, VRAM, and the VRM (voltage regulation module) as cooling liquid is channeled right over these critical areas. The water block is in contact with MOSFETs and chokes to maximize cooling and minimize the chances of unwanted coil whine. The flow paths are optimized to reduce hydrodynamic instabilities and vortexing (dead spots) inside of them.The integrated Open Split-Flow cooling engine design proved to be a superior solution for GPU water blocks. It is characterized by low hydraulic flow restriction, meaning it can be used with weaker water pumps or pumps running on low-speed settings and still achieve top performance.This water block comes with an included backplate that makes sure the entire graphics card is enclosed and not at all visible. It also provides additional passive cooling for the GPU core and backside of the printed circuit board VRM section.The water block is delivered with a terminal featuring 6 G1/4" ports. Two direct G1/4" ports on the side, and four G1/4" ports going through it - two from the top, and two from the bottom.This water block boasts a whopping 20 individually addressable D-RGB LEDs that illuminate both the water block's interior and the terminal itself. It is compatible with all popular RGB Sync technologies from major motherboard manufacturers.Technical Specification:- Dimensions: (LxHxW) - 209.5x97.5x28.5mm- D-RGB cable length: 500mm- D-RGB LED count: 20- D-RGB connector standard 3-pin (+5V, Data, Blocked, Ground) Model: 3831109860618