ESSMO Copper Orange Glitter Heat Transfer Vinyl HTV Sheet T-Shirt 20" Wide Iron On Heat Press DG10 20"x12"

Material Specification:

• PU Composition
• Thickness:230 Microns / 9.8 Mils (Please make sure plotter is capable of cutting such thickness)
• Heat pressure sensitive backing
• Glitter Finish

Application Instruction (Home Iron)

• Set iron dial between Cotton and Linen
• Cover design with Kraft paper or non-stick cover sheet
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 10-15 seconds
• If areas of design lift after application, replace cover sheet and re-press for 5-10 seconds
• let it cool for about 30-45 seconds and then gently peel back the clear plastic until it is completely removed.

Application Instructions (Heat Press)

• Cut in reverse
• Weed excess material
• Preheat all fabric prior to pressing for best results
• Apply design at 305°F/150°C-160°C for 12-15 seconds
• let it cool for about 30-45 seconds and then gently peel back the clear plastic until it is completely removed.

Applies to:

• 100% Cotton
• Poly / Cotton Blends
• 100% Polyester
• Leather

Laundering:

• Wait 24 hours before 1st wash
• Machine wash warm or cold / mild detergent (Max 60°C)
• Dry on normal dryer setting
• Do not bleach or dry clean