Smoke Motorcycle Flush Mount Turn Signal Suzuki GSXR Honda CBR Kawa Ninja Yamaha

1 Pair - Universal Translucent Smoked Surface Mount Turn Signals
Medium Cat Eye Clear Smoked Lens - Amber Bulb
Are you tired of bumping into your old, over-sized side markers? Do you need to replace a broken OEM Turn Signal Light and want a clean finish look? We have just the Blinker for you. Upgrade with our bright Universal Surface Mount Turn Signals. Our Signals offer a low profile designed Lens, an incandescent Bulb, and a High Impact Plastic Housing. These Signals are universal, so you can install them on the front or rear of your Motorcycle, ATV, UTV, or Scooter with little or no modification required depending on your application.
Stats:
Name: Tiger
Dimensions: Multiple, please see photo(s)
Housing: High Impact Plastic, Translucent Smoked Lens
Bulb: Amber Incandescent Bulb, Single Filament, 12 Volt, 10 Watt, 1156 Style Base
Wiring: Two Wire, 12 Volt Systems, approximate Length of Wires = 13.5 inch (343mm)
Fitment Information: This is a Universal Turn Signal Light; therefore, it has unlimited uses and mounting possibilities. This includes, but is not limited to: Sportbikes, Cruisers, Scooters, ATV, Quad, UTV, MX, Dirt Bike, Enduro, Dual Sport, Golf Carts, and even Snowmobiles.
Note: You are purchasing and will receive the color listed in the Title and Description. Install Notes: Always test the lights before installation to ensure they work properly. After testing, we recommend disconnecting the battery before starting signal installation. The installation difficulty will vary depending on your application; depending on where you decide to mount them, it may require modification to the fairing. Once you pick a mounting location, you'll need to locate the existing Turn Signal Wires on your Motorcycle and identify whether you have 2 or 3 Wire System. For a motorcycle with a 3 Wire System: your Running Light Wires are not used for this installation asour lights are not designed or marketed for that application. For a2 Wire System: the two wires coming from your bike should be the Turn Signal Power (Positive Wire), and a Ground (Negative Wire). Attach our RED Turn Signal Wire to the Bikes Positive Signal Wire. Attach our BLACK Turn Signal Wire to the Bikes Negative Signal Wire. Test the light and ensure it functions properly prior to putting everything back together. If it's good, repeat the process for the other side. Reassemble, Ride and Enjoy! Do not over-torque the plastic mounting nut onto the bolt when installing, it should be snugged, hand-tight and not forcefully clamped down. You may use a little Silicon Plumbers Tape on the plastic bolt thread and then hand tighten the plastic nut (Do not over-wrap).