Product Overview
Spindle motor has the advantages of fast speed, small volume, lightweight, low material consumption, low noise, low vibration. It is widely used in wood, aluminum, metal, stone, metal, plastic and other materials carving processing, widely used in many industries, can greatly improve the processing quality and accuracy.
Parameters
Voltage:220V
Power: 4.5kw(6HP)
Current: 20.45A
Operating Frequency: 300Hz
Collet Nut: ER32
Clamping Range: 0.118"-0.787"(3mm-20mm)[Standard with 6mm collet, if you need other sizes please contact us]
Clamping Diameter of Collet: 0.236"(6mm)
Motor Speed: 18000rpm
Cone Hole Beat: 2UM
Cooling Mode: Fan Cooling
Lubrication Mode: Grease Lubrication
Fuselage Material: Pure Aluminium
Product Size: 14.8"*5.4"*6.1"(37.5cm*13.7cm*15.5cm)
Item size: 14.8x5.4x6.1inch/37.5x13.7x15.5cm
Net weight: 29.1LB(13.2kg)
NOTE: Spindle motor must be equipped with frequency converter.Set up frequency converter correctly according to machine requirement. The item is not included frequency converter.
Matters Need Attention
- must match the drive spindle chosen correctly according to the electric spindle nameplate good debugging power, voltage and frequency.
- Set the frequency converter should be set command channel, and then set the display channel, and finally set the parameters. When setting parameters, be sure that the reference frequency, the frequency of the three highest rated frequency and consistency.
- The spindle is generally clockwise in the wrong direction, the drive can change settings or swap any two rotating wire the inverter output UVW terminal on.
- In general, water-cooled spindle surface temperature and ambient temperature greater than 20 degrees, the heat can be considered a spindle; when air-cooled spindle surface temperature greater than ambient temperature of 30 degrees, can be identified as the main heat seriously, immediately shut down cooling, a check.
Item Included: 053288-TopS1
INTBUYING Spindle Motor *1
Fork Wrench *1
Collet Wrench *1
