Metal Smoke Generator for RC Climbing Cars Compatible with Axial SCX10 III, Easy Install

Features:
RC Car Simulation Exhaust Smoke Generator.
For Axial, For SCX10 III 1/10 Climbing Car.
Made of high-quality metal material, durable use.
For enthusiasts to updrade or modify their rc models.
The smoker is suitable for most models of remote control climbing cars, military trucks, dump trucks, drift cars, boats, etc. on the market
Voltage: 7.4V-11.1V

Instructions:
1. Connect the signal wire of the smoke emitter to the receiver, the red wire-the PWM signal; the black wire-the positive pole of the receiver's power supply.
2. Turn on the remote control first, then turn on the receiver, otherwise the smoke generator may keep rotating after the receiver is turned on until the remote control is turned on.
3. Description of the working status of the smoker: After starting, the smoker is in the standby state (will not operate); touch the throttle lever, the smoker enters the idling state; the throttle lever moves up and down, and the speed of the smoker changes accordingly. After the throttle stick does not move for about 15 seconds, the smoke generator enters the standby state until it touches the throttle stick again.

Package Includes:
1 Piece Generation Exhaust
1 Piece Split Air Pump
1 Piece Smoke Control Circuit Board
1 Piece Silicone Tube

Note:
Colors might be different due to different monitor display.
Please allow slightly difference in size due to manual measurement.