Rectangle Shifter Boot with Billet Aluminum Ring for Hot Rods: Black Anodized Finish, Premium Vinyl, 6-3/4" x 5-1/4", Easy Installation, Includes Stainless Steel Screws

1/4-inch thick 6061-T6 billet aluminum shift boot ring CNC machined with 3D reliefs. Available in rectangle and round designs to fit any floor or console. Offered in bare satin, highly polished, and black anodized finishes. Includes 1.5mm thick flame retardant leather-look universal shift boot. Shifter boot 3/8-inch top opening accommodates flat and round shifter levers. Comes complete with stainless hex drive flathead screws and nylon locking nuts. Matching floor-mount and trans-mount parking brake lever trim rings available. Complement Any Interior with Our Billet Aluminum Shifter Bezel There’s something ultimately cool about having your transmission’s shifter mounted on the floor of your ride. Be it a manual or automatic transmission, having that shift lever poking up through your floor just screams performance, even if it is a completely stock small block with iron manifolds! Whether you’re looking to convert your ride from its factory column shift to floor shift, or you’re looking to ditch your stock floor shifter for something cooler and more capable, you’re going to want to dress up your installation with a custom shift boot and shift boot ring to finish off the installation. We have designed a complete line of 6061-T6 billet aluminum shifter bezels (and matching parking brake bezel kits) available in a brushed finish, polished finish, and black anodized. Offered in both rectangular and round shifter bezel designs, simply choose the shape and finish that best compliments your interior. These shifter bezels can be direct mounted to your floor or used in conjunction with factory, aftermarket, or custom built consoles. Installation of these bezels and included custom shift boot work with both automatic and manual transmissions. Ready To Install with a Pre-Sewn Leather-Look Shifter Boot and Stainless Hardware At just 1/4-inch thick and machined with a light three-dimensional line of ball milled pockets/recesses into the surface, this shift boot ring will work with both stock and custom interiors and can be gently bent to conform to the curvature of your transmission tunnel. The included round shifter boot is made from a flame retardant material with a black leather-like grain texture. The boot comes pre-sewn and features reinforced stitching at the 3/8-inch shift lever opening. The shift lever opening can accommodate both round and flat shift levers. The included bright stainless steel hex drive flat head screws secure the shift boot ring and universal shift boot to your car’s floor or console with the matching nylon locking nuts and flat washers. The shifter bezel is generously sized to clear most floor mount automatic shifters and all transmission mounted automatic or manual shifter assemblies. The rectangular shifter bezel is sized at  6-3/4” x 5-1/4” OD with a 5-1/2” x 4” ID. The round shift boot ring is slightly smaller at 5-1/8” OD with a 3-7/8” ID. Matching parking brake bezel/boot kits are available in all three finishes for both floor mounted brake mechanisms and transmission mounted brake mechanisms.