PAC SWI-RC Steering Wheel Control Interface With PAC C2R-FRD1 Radio Replacement Interface for Select 2005-up CAN-bus Ford, Lincoln and Mercury Vehicles

• The aftermarket radio MUST be equipped with a wired remote input (3.5mm headphone style jack or Blue/Yellow wire) to be compatible (ex. a port or wire on the back of the radio labeled W/R, REM, Wired Remote, Remote, Rem Cont etc.). If the radio does not have a wired remote input then you will need to use the SWI-X.
• Not compatible with Sony models: XAV-AX100, XAV-W650BT, XAV-W651BT, XAV-W630BT, XAV-W631BT. These models must be used with the?SWI-CP5?or?SWI-CP2.
• Not compatible with Kenwood models: KDC-X598, KDC-BT318U, KDCBT-758-HD, KDCBT-558U & KDC-X798. These models must be used with the?SWI-CP5?or?SWI-CP2.
• Clarion model CZ500 does not support remote Bluetooth controls
• Pioneer radios with Bluetooth feature, the steering wheel controls will not adjust the phone call volume.? The phone call volume must be adjusted on the face of the radio.? This is a limitation of the radio not the SWI-RC.?There is no correction for this unless it comes from Pioneer.
• Only the AVIC-Z110BT, Z120BT, Z130BT, Z140BH and the AVIC-X920BT, X930BT, X940BT will support the Voice Recognition function via wired remote input.

C2R-FRD1

• Compatible with THX, SONY, Shaker and Audiophile sound systems in applicable vehicles. (v1.1.4 or higher required)
• Data controlled RAP accessory output wire
• Data controlled parking brake wire
• Data controlled reverse trigger wire
• Data controlled vehicle speed sense wire
• Data controlled illumination output wire
• Retains factory-installed amplified audio system
• Retains rear seat entertainment and dual zone audio



• PAC SWI-RC Retains steering wheel control functions when replacing the factory radio, Retains programming even if the vehicle's battery is disconnected, Control functions such as volume, mode and track on most Pioneer, Sony, JVC, Alpine, Clarion, Kenwood, Blaupunkt, Jensen, Dual, Advent, OEM, Valor and Visteon radios equipped with a wired remote control input
• Not compatible with Kenwood models: KDC-X598, KDC-BT318U, KDCBT-758-HD, KDCBT-558U & KDC-X798. These models must be used with the SWI-CP5.
• PAC C2R-FRD1 Radio Replacement Interface for Select 2005-up MSCAN-bus Ford, Lincoln and Mercury Vehicles, Enables factory features such as rear seat entertainment, rear controls, and the THXII amp when the factory radio is replaced
• Provides RAP accessory power output, vehicle speed, illumination, reverse indication output and parking brake output signal to allow easy installation of an aftermarket NAV system, Radio Replacement Interface for Select 2005-up MSCAN-bus Ford, Lincoln and Mercury Vehicles
• Enables factory features such as rear seat entertainment, rear controls, and the THXII amplifier when the factory radio is replaced, Also provides RAP accessory power output, vehicle speed, illumination, reverse indication output and parking brake ouput signal to allow easy installation of an aftermarket NAV system, Compatible with THX, SONY, Shaker and Audiophile sound systems in applicable vehicles. (v1.1.4 or higher required)